國家衛生研究院 NHRI:Item 3990099045/12273
English  |  正體中文  |  简体中文  |  全文筆數/總筆數 : 12500/13673 (91%)
造訪人次 : 2847333      線上人數 : 287
RC Version 6.0 © Powered By DSPACE, MIT. Enhanced by NTU Library IR team.
搜尋範圍 查詢小技巧：
  • 您可在西文檢索詞彙前後加上"雙引號"，以獲取較精準的檢索結果
  • 若欲以作者姓名搜尋，建議至進階搜尋限定作者欄位，可獲得較完整資料
    •  進階搜尋
    主頁 ‧ 登入 ‧ 上傳 ‧ 說明 ‧ 關於NHRI ‧ 管理 到手機版


    請使用永久網址來引用或連結此文件: http://ir.nhri.org.tw/handle/3990099045/12273


    題名: Abutment screw withdrawal after conical abutment settlement: A pilot study
    作者: Yao, KT;Chang, TY;Fang, HW;Huang, CH;Wang, DH;Hsu, ML
    貢獻者: Institute of Biomedical Engineering and Nanomedicine
    摘要: OBJECTIVE: This study investigated the effects of abutment screw withdrawal after conical abutment settlement on the stability of the implant-abutment connection. MATERIAL AND METHODS: Twenty implants of a conical connection system were used. Two two-piece abutment designs were used: cone only (n = 10; NI) and cone plus octagonal index design (n = 10; I); for each design, five samples were used with (S) and without (NS) abutment screw withdrawal before a cyclic test. Finally, four groups, namely Gr S(NI), Gr S(I), Gr NS(NI), and Gr NS(I), were included. The cyclic test included cyclic loading of 20-200 N, 30 degrees , and 4-mm off-axis to implant axis at 10 Hz for 10(6) cycles, simulating a clinical time interval of 40 months. The fatigue cycles were recorded. The axial displacement of the conical abutments during abutment settlement, screw withdrawal, and cyclic loading were measured. Abutment morphology was examined through scanning electron microscopy (SEM). RESULTS: Only Gr NS(NI) failed the test, indicating that without the index design and abutment screw withdrawal, connection stability seriously deteriorated. Gr NS(I) exhibited significantly higher axial displacement into the implant after abutment settlement than did Gr NS(NI). It also exhibited continuous axial displacement into the implant after cyclic loading. SEM after cyclic testing in Gr NS(I) revealed marked burnishing on lateral edges of the index, indicating that the index design provides an antitorsional ability. CONCLUSION: Although this study has few limitations, abutment screw withdrawal is feasible in this conical implant-abutment connection system with index design.
    日期: 2020-02
    關聯: Clinical Oral Implants Research. 2020 Feb;31(2):144-152.
    Link to: http://dx.doi.org/10.1111/clr.13550
    JIF/Ranking 2023: http://gateway.webofknowledge.com/gateway/Gateway.cgi?GWVersion=2&SrcAuth=NHRI&SrcApp=NHRI_IR&KeyISSN=0905-7161&DestApp=IC2JCR
    Cited Times(WOS): https://www.webofscience.com/wos/woscc/full-record/WOS:000497477400001
    Cited Times(Scopus): https://www.scopus.com/inward/record.url?partnerID=HzOxMe3b&scp=85075330860
    顯示於類別:[其他] 期刊論文

    文件中的檔案:

    檔案 大小格式瀏覽次數
    PUB31647133.pdf23424KbAdobe PDF473檢視/開啟


    在NHRI中所有的資料項目都受到原著作權保護.

    TAIR相關文章

    DSpace Software Copyright © 2002-2004  MIT &  Hewlett-Packard  /   Enhanced by   NTU Library IR team Copyright ©   - 回饋